A
DDRESS
T
ABLE
C
OMMANDS
4-189
- action -
• delete-on-reset - Assignment lasts until the switch is reset.
• permanent - Assignment is permanent.
Default Setting
No static addresses are defined. The default mode is permanent.
Command Mode
Global Configuration
Command Usage
The static address for a host device can be assigned to a specific port
within a specific VLAN. Use this command to add static addresses to
the MAC Address Table. Static addresses have the following
characteristics:
• Static addresses will not be removed from the address table when a
given interface link is down.
• Static addresses are bound to the assigned interface and will not be
moved. When a static address is seen on another interface, the address
will be ignored and will not be written to the address table.
• A static address cannot be learned on another port until the address is
removed with the no form of this command.
Example
clear mac-address-table dynamic
This command removes any learned entries from the forwarding database
and clears the transmit and receive counts for any static or system
configured entries.
Default Setting
None
Command Mode
Privileged Exec
Console(config)#mac-address-table static 00-12-cf-94-34-de
interface ethernet 1/1 vlan 1 delete-on-reset
Console(config)#
To Next Page
Loading...
Need help?
General
