SMC Networks TigerSwitch SMC6128PL2 User Manual

S YSTEM M ANAGEMENT C OMMANDS
4-47
This section describes the commands used to configure the SSH server.
However, note that you also need to install a SSH client on the
management station when using this protocol to configure the switch.
Note: The switch supports both SSH Version 1.5 and 2.0.
Table 4-15 SSH Commands
Command Function Mod
e
Pag
e
ip ssh server Enables the SSH server on the switch GC 4-49
ip ssh timeout Specifies the authentication timeout for the SSH
server
GC 4-50
ip ssh
authentication-re
tries
Specifies the number of retries allowed by a
client
GC 4-51
ip ssh server-key
size
Sets the SSH server key size GC 4-52
copy tftp
public-key
Copies the user’s public key from a TFTP server
to the switch
PE 4-88
delete public-key Deletes the public key for the specified user PE 4-52
ip ssh crypto
host-key generate
Generates the host key PE 4-53
ip ssh crypto
zeroize
Clear the host key from RAM PE 4-54
ip ssh save
host-key
Saves the host key from RAM to flash memory PE 4-55
disconnect Terminates a line connection PE 4-25
show ip ssh Displays the status of the SSH server and the
configured values for authentication timeout and
retries
PE 4-55
show ssh Displays the status of current SSH sessions PE 4-55
show public-key Shows the public key for the specified user or for
the host
PE 4-57
show users Shows SSH users, including privilege level and
public key type
PE 4-85

SMC Networks TigerSwitch SMC6128PL2 Specifications

General

Brand	SMC Networks
Model	TigerSwitch SMC6128PL2
Category	Switch
Language	English