S
YSTEM
M
ANAGEMENT
C
OMMANDS
4-67
The following example displays settings for the trap function.
Related Commands
show logging sendmail (4-72)
show log
This command displays the system and event messages stored in memory.
Syntax
show log {flash | ram} [login] [tail]
- flash - Event history stored in flash memory (i.e., permanent
memory).
- ram - Event history stored in temporary RAM (i.e., memory
flushed on power reset).
- tail - Shows event history starting from the most recent entry.
Console#show logging trap
Syslog logging: Enable
REMOTELOG status: disable
REMOTELOG facility type: local use 7
REMOTELOG level type: Debugging messages
REMOTELOG server IP address: 1.2.3.4
REMOTELOG server IP address: 0.0.0.0
REMOTELOG server IP address: 0.0.0.0
REMOTELOG server IP address: 0.0.0.0
REMOTELOG server IP address: 0.0.0.0
Console#
Table 4-20 show logging trap - display description
Field Description
Syslog logging Shows if system logging has been enabled via the logging on
command.
REMOTELOG
status
Shows if remote logging has been enabled via the logging trap
command.
REMOTELOG
facility type
The facility type for remote logging of syslog messages as
specified in the logging facility command.
REMOTELOG
level type
The severity threshold for syslog messages sent to a remote
server as specified in the logging trap command.
REMOTELOG
server IP address
The address of syslog servers as specified in the logging host
command.
To Next Page
Loading...
Need help?
General
