C
ONFIGURING
THE
S
WITCH
3-26
If you download to a new destination file, go to the System/File/Set
Start-Up menu, mark the operation code file used at startup, and click
Apply. To start the new firmware, reboot the system via the System/Reset
menu.
Figure 3-10. Setting the Startup Code
To delete a file select System, File, Delete. Select the file name from the
given list by checking the tick box and click Apply. Note that t
he file currently
designated as the startup code cannot be deleted.
Figure 3-11. Deleting Files
CLI – To download new firmware form a TFTP server, enter the IP
address of the TFTP server, select “opcode” as the file type, then enter the
source and destination file names. When the file has finished downloading,
set the new file to start up the system, and then restart the switch.
To start the new firmware, enter the “reload” command or reboot the
system.
To Next Page
Loading...
Need help?
General
