4-206
Example
spanning-tree spanning-disabled
This command disables the spanning tree algorithm for the specified
interface. Use the no form to reenable the spanning tree algorithm for the
specified interface.
Syntax
[no] spanning-tree spanning-disabled
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
This example disables the spanning tree algorithm for port 5.
spanning-tree cost
This command configures the spanning tree path cost for the specified
interface. Use the no form to restore the default.
Syntax
spanning-tree cost cost
no spanning-tree cost
cost - The path cost for the port.
(Range: 0 for auto-configuration, or 1-200,000,000)
The recommended range is:
• Ethernet: 200,000-20,000,000
• Fast Ethernet: 20,000-2,000,000
• Gigabit Ethernet: 2,000-200,000
• 10 Gigabit Ethernet: 200-20,000
Console(config-mstp)#max-hops 30
Console(config-mstp)#
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree spanning-disabled
Console(config-if)#
To Next Page
Loading...
Need help?
General
