SMC Networks TigerSwitch SMC6128PL2

VLAN C OMMANDS
4-225
The following example adds a VLAN, using VLAN ID 105 and name
RD5. The VLAN is activated by default.
Related Commands
show vlan (4-233)
Configuring VLAN Interfaces
interface vlan
This command enters interface configuration mode for VLANs, which is
used to configure VLAN parameters for a physical interface.
Syntax
Console(config)#vlan database
Console(config-vlan)#vlan 105 name RD5 media ethernet
Console(config-vlan)#
Configuring VLAN Interfaces
Command Function Mode Page
interface vlan Enters interface configuration mode for
a specified VLAN
GC 4-225
switchport mode Configures VLAN membership mode
for an interface
IC 4-226
switchport
acceptable-frame-types
Configures frame types to be accepted by
an interface
IC 4-227
switchport
ingress-filtering
Enables ingress filtering on an interface IC 4-228
switchport native vlan Configures the PVID (native VLAN) of
an interface
IC 4-229
switchport allowed vlan Configures the VLANs associated with
an interface
IC 4-230
switchport gvrp Enables GVRP for an interface IC 4-219
switchport forbidden
vlan
Configures forbidden VLANs for an
interface
IC 4-231
switchport priority
default
Sets a port priority for incoming
untagged frames
IC 4-249