B
ASIC
C
ONFIGURATION
3-29
Downloading Configuration Settings from a Server
You can download the configuration file under a new file name and then
set it as the startup file, or you can specify the current startup
configuration file as the destination file to directly replace it. Note that the
file “Factory_Default_Config.cfg” can be copied to the TFTP server, but
cannot be used as the destination on the switch.
Web – Click System, File, Copy Operation. Select “tftp to startup-config”
or “tftp to file” and enter the IP address of the TFTP server. Specify the
name of the file to download and select a file on the switch to overwrite or
specify a new file name, then click Apply.
Figure 3-12. Downloading Configuration Settings for Startup
If you download to a new file name using “tftp to startup-config” or “tftp
to file,” the file is automatically set as the start-up configuration file. To use
the new settings, reboot the system via the System/Reset menu.
Note: You can also select any configuration file as the start-up
configuration by using the System/File/Set Start-Up page.
To Next Page
Loading...
Need help?
General
