4-190
Example
show mac-address-table
This command shows classes of entries in the bridge-forwarding database.
Syntax
show mac-address-table [address mac-address [mask]] [interface
interface] [vlan vlan-id] [sort
{address | vlan | interface}]
- mac-address - MAC address.
- mask - Bits to match in the address.
- interface
• ethernet unit/port
- unit - Stack unit. (Always unit 1)
- port - Port number. (Range: 1-52)
• port-channel channel-id (Range: 1-8)
- vlan-id - VLAN ID (Range: 1-4094)
- sort - Sort by address, vlan or interface.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• The MAC Address Table contains the MAC addresses associated with
each interface. Note that the Type field may include the following
types:
- Learned - Dynamic address entries
- Permanent - Static entry
- Delete-on-reset - Static entry to be deleted when system is reset
• The mask should be hexadecimal numbers (representing an equivalent
bit mask) in the form xx-xx-xx-xx-xx-xx that is applied to the specified
MAC address. Enter hexadecimal numbers, where an equivalent
binary bit “0” means to match a bit and “1” means to ignore a bit. For
Console#clear mac-address-table dynamic
Console#
To Next Page
Loading...
