C
OMMAND
L
INE
I
NTERFACE
4-150
snmp-server group
This command adds an SNMP group, mapping SNMP users to SNMP
views. Use the no form to remove an SNMP group.
Syntax
snmp-server group groupname {v1 | v2c | v3 {auth | noauth |
priv}} [read
readview] [write writeview] [notify notifyview]
no snmp-server group groupname
-groupname - Name of an SNMP group. (Range: 1-32 characters)
-v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
-auth | noauth | priv - This group uses SNMPv3 with
authentication, no authentication, or with authentication and
privacy. See “Simple Network Management Protocol” on page 5-1
for further information about these authentication and encryption
options.
-readview - Defines the view for read access. (1-64 characters)
-writeview - Defines the view for write access. (1-64 characters)
- notifyview - Defines the view for notifications. (1-64 characters)
Default Setting
• Default groups: public
17
(read only), private
18
(read/write)
• readview - Every object belonging to the Internet OID space (1.3.6.1).
• writeview - Nothing is defined.
• notifyview - Nothing is defined.
Command Mode
Global Configuration
Command Usage
•A group sets the access policy for the assigned users.
•When authentication is selected, the MD5 or SHA algorithm is used as
specified in the
snmp-server user command.
•When privacy is selected, the DES 56-bit algorithm is used for data
encryption.
17. No view is defined.
18. Maps to the defaultview.
To Next Page
Loading...
Need help?
General
