C
ONFIGURING
THE
S
WITCH
3-30
Figure 3-13. Setting the Startup Configuration Settings
CLI – Enter the IP address of the TFTP server, specify the source file on
the server, set the startup file name on the switch, and then restart the
switch.
To select another configuration file as the start-up configuration, use the
boot system command and then restart the switch.
This example shows how to download a PoE controller file from a TFTP
server.
Console#copy tftp startup-config 4-88
TFTP server ip address: 192.168.1.19
Source configuration file name: config-1
Startup configuration file name [] : startup
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#reload
Console#config
Console(config)#boot system config: startup-new 4-95
Console(config)#exit
Console#reload
4-30
Console#copy tftp file 4-82
TFTP server IP address: 10.3.4.50
Choose file type:
1. config: 2. opcode 3. PD_Controller: <1-3>: 3
Source file name: 7012_007.s19
Destination file name: PoE-test
Write to FLASH Programming.
Write to FLASH finish.
Success.
Console#
To Next Page
Loading...
Need help?
General
