C
ONFIGURING
THE
S
WITCH
3-144
• If a device is connected to a critical or high-priority port and causes the
switch to exceed its budget, port power is turned on, but the switch drops
power to one or more lower-priority ports.
Note: Power is dropped from low-priority ports in sequence starting
from port number 1.
Command Attributes
• Port – The port number on the switch.
• Admin Status – Enables PoE power on the port. Power is automatically
supplied when a device is detected on the port, providing that the power
demanded does not exceed the switch or port power budget.
(Default: Enabled)
• Priority – Sets the power priority for the port. (Options: low, high, or
critical; Default: low)
• Power Allocation – Sets the power budget for the port.
(Range: 3000- 15400 milliwatts; Default: 15400 milliwatts)
Web – Click PoE, Power Port Configuration. Enable PoE power on
selected ports, set the priority and the power budget, and then click Apply.
Figure 3-63 Configuring Port PoE Power
To Next Page
Loading...
