SNMP C
OMMANDS
4-139
Example
snmp-server community
This command defines the SNMP v1 and v2c community access string.
Use the no form to remove the specified community string.
Syntax
snmp-server community string [ro|rw]
no snmp-server community string
-string - Community string that acts like a password and permits access
to the SNMP protocol. (Maximum length: 32 characters, case
sensitive; Maximum number of strings: 5)
-ro - Specifies read-only access. Authorized management stations are
only able to retrieve MIB objects.
Console#show snmp
SNMP Agent: enabled
SNMP traps:
Authentication: enable
Link-up-down: enable
SNMP communities:
1. private, and the privilege is read-write
2. public, and the privilege is read-only
0 SNMP packets input
0 Bad SNMP version errors
0 Unknown community name
0 Illegal operation for community name supplied
0 Encoding errors
0 Number of requested variables
0 Number of altered variables
0 Get-request PDUs
0 Get-next PDUs
0 Set-request PDUs
0 SNMP packets output
0 Too big errors
0 No such name errors
0 Bad values errors
0 General errors
0 Response PDUs
0 Trap PDUs
SNMP logging: disabled
Console#
To Next Page
Loading...
Need help?
General
