4-282
Multicast VLAN Registration Commands
This section describes commands used to configure Multicast
VLAN Registration (MVR). A single network-wide VLAN can be
used to transmit multicast traffic (such as television channels)
across a service provider’s network. Any multicast traffic entering
an MVR VLAN is sent to all subscribers. This can significantly
reduce to processing overhead required to dynamically monitor
and establish the distribution tree for a normal multicast VLAN.
Also note that MVR maintains the user isolation and data security
provided by VLAN segregation by passing only multicast traffic
into other VLANs to which the subscribers belong.
Multicast VLAN Registration Commands
Command Function Mode Page
mvr Globally enables MVR, statically configures MVR
group address(es), or specifies the MVR VLAN
identifier
GC 4-283
mvr Configures an interface as an MVR receiver or
source port, enables immediate leave capability,
or configures an interface as a static member of
the MVR VLAN
IC 4-284
show mvr Shows information about the global MVR
configuration settings, the interfaces attached to
the MVR VLAN, or the multicast groups
assigned to the MVR VLAN
PE 4-287
To Next Page
Loading...
Need help?
General
