C
OMMAND
L
INE
I
NTERFACE
4-44
ip http secure-port
This command specifies the UDP port number used for HTTPS
connection to the switch’s web interface. Use the no form to restore the
default port.
Syntax
ip http secure-port port_number
no ip http secure-port
port_number – The UDP port used for HTTPS.
(Range: 1-65535)
Default Setting
443
Command Mode
Global Configuration
Command Usage
• You cannot configure the HTTP and HTTPS servers to use the same
port.
• If you change the HTTPS port number, clients attempting to connect
to the HTTPS server must specify the port number in the URL, in this
format:
https://device:port_number
Example
Related Commands
ip http secure-server (4-42)
Console(config)#ip http secure-port 1000
Console(config)#
To Next Page
Loading...
