4-270
ip igmp snooping
This command enables IGMP snooping on this switch. Use the no form
to disable it.
Syntax
[no] ip igmp snooping
Default Setting
Enabled
Command Mode
Global Configuration
Example
The following example enables IGMP snooping.
ip igmp snooping vlan static
This command adds a port to a multicast group. Use the no form to
remove the port.
Syntax
[no] ip igmp snooping vlan vlan-id static ip-address interface
- vlan-id - VLAN ID (Range: 1-4094)
- ip-address - IP address for multicast group
- interface
• ethernet unit/port
- unit - Stack unit. (Always unit 1)
- port - Port number. (Range: 1-52)
• port-channel channel-id (Range: 1-8)
Default Setting
None
Command Mode
Console(config)#ip igmp snooping
Console(config)#