SMC Networks TigerSwitch SMC6128PL2 User Manual

4-248
Priority Commands (Layer 2)
queue mode
This command sets the queue mode to strict priority or Weighted
Round-Robin (WRR) for the class of service (CoS) priority queues. Use the
no form to restore the default value.
Syntax
queue mode {strict | wrr}
no queue mode
- strict - Services the egress queues in sequential order, transmitting
all traffic in the higher priority queues before servicing lower
priority queues.
- wrr - Weighted Round-Robin shares bandwidth at the egress ports
by using scheduling weights 1, 2, 4, 8 for queues 0 - 3 respectively.
Default Setting
Weighted Round Robin
Priority Commands (Layer 2)
Command Function Mod
e
Page
queue mode Sets the queue mode to strict priority or
Weighted Round-Robin (WRR)
GC 4-248
switchport priority
default
Sets a port priority for incoming untagged
frames
IC 4-249
queue bandwidth Assigns round-robin weights to the priority
queues
GC 4-250
queue cos map Assigns class-of-service values to the
priority queues
IC 4-251
show queue mode Shows the current queue mode PE 4-252
show queue
bandwidth
Shows round-robin weights assigned to the
priority queues
PE 4-253
show queue cos-map Shows the class-of-service map PE 4-253
show interfaces
switchport
Displays the administrative and
operational status of an interface
PE 4-168

SMC Networks TigerSwitch SMC6128PL2 Specifications

General

Brand	SMC Networks
Model	TigerSwitch SMC6128PL2
Category	Switch
Language	English