A
CCESS
C
ONTROL
L
ISTS
3-97
3. Explicit default rule (permit any any) in the ingress IP ACL for ingress
ports.
4. If no explicit rule is matched, the implicit default is permit all.
Setting the ACL Name and Type
Use the ACL Configuration page to designate the name and type of
an ACL.
Command Attributes
• Name – Name of the ACL. (Maximum length: 15 characters)
• Type – There are three filtering modes:
- Standard – IP ACL mode that filters packets based on the source
IP address.
- Extended – IP ACL mode that filters packets based on source or
destination IP address, as well as protocol type and protocol port
number.
- MAC – MAC ACL mode that filters packets based on the source or
destination MAC address and the Ethernet frame type (RFC 1060).
To Next Page
Loading...
Need help?
General
