SMC Networks TigerSwitch SMC6128PL2 User Manual

4-188
Address Table Commands
These commands are used to configure the address table for filtering
specified addresses, displaying current entries, clearing the table, or setting
the aging time.
mac-address-table static
This command maps a static address to a destination port in a VLAN. Use
the no form to remove an address.
Syntax
mac-address-table static mac-address interface interface
vlan
vlan-id [action]
no mac-address-table static mac-address vlan vlan-id
- mac-address - MAC address.
- interface
• ethernet unit/port
- unit - Stack unit. (Always unit 1)
- port - Port number. (Range: 1-52)
• port-channel channel-id (Range: 1-8)
- vlan-id - VLAN ID (Range: 1-4094)
Address Table Commands
Command Function Mode Page
mac-address-table
static
Maps a static address to a port in a VLAN GC 4-188
clear
mac-address-table
dynamic
Removes any learned entries from the
forwarding database
PE 4-189
show
mac-address-table
Displays entries in the bridge-forwarding
database
PE 4-190
mac-address-table
aging-time
Sets the aging time of the address table GC 4-191
show
mac-address-table
aging-time
Shows the aging time for the address table PE 4-191

SMC Networks TigerSwitch SMC6128PL2 Specifications

General

Brand	SMC Networks
Model	TigerSwitch SMC6128PL2
Category	Switch
Language	English