SMC Networks TigerSwitch SMC6128PL2

S PANNING T REE C OMMANDS
4-195
Command Mode
Global Configuration
Command Usage
The Spanning Tree Algorithm (STA) can be used to detect and disable
network loops, and to provide backup links between switches, bridges
or routers. This allows the switch to interact with other bridging
devices (that is, an STA-compliant switch, bridge or router) in your
network to ensure that only one route exists between any two stations
on the network, and provide backup links which automatically take over
when a primary link goes down.
Example
This example shows how to enable the Spanning Tree Algorithm for the
switch:
spanning-tree mode
This command selects the spanning tree mode for this switch. Use the no
form to restore the default.
Note: MSTP is not supported in the current software.
Syntax
spanning-tree mode {stp | rstp | mstp}
no spanning-tree mode
- stp - Spanning Tree Protocol (IEEE 802.1D)
- rstp - Rapid Spanning Tree Protocol (IEEE 802.1w)
- mstp - Multiple Spanning Tree (IEEE 802.1s)
Default Setting
rstp
Command Mode
Global Configuration
Command Usage
• Spanning Tree Protocol
Console(config)#spanning-tree
Console(config)#