4-230
switchport allowed vlan
This command configures VLAN groups on the selected interface. Use
the no form to restore the default.
Note: Each port can only have one untagged VLAN. If a second VLAN is defined
for a port as untagged, the other VLAN that had untagged status will
automatically be changed to tagged. Setting a VLAN untagged will also
change the native VLAN of the port to this VLAN.
Syntax
switchport allowed vlan {add vlan-list [tagged | untagged] |
remove
vlan-list}
no switchport allowed vlan
- add vlan-list - List of VLAN identifiers to add.
- remove vlan-list - List of VLAN identifiers to remove.
- vlan-list - Separate nonconsecutive VLAN identifiers with a comma
and no spaces; use a hyphen to designate a range of IDs. Do not
enter leading zeros. (Range: 1-4094).
Default Setting
All ports are assigned to VLAN 1 by default.
The default frame type is untagged.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• A port, or a trunk with switchport mode set to hybrid, must be
assigned to a VLAN as untagged.
• If a trunk has switchport mode set to trunk (i.e., 1Q Trunk), then you
can only assign an interface to VLAN
groups as a tagged member.
• Frames are always tagged within the switch. The tagged/untagged
parameter used when adding a VLAN to an interface tells the switch
whether to keep or remove the tag from a frame on egress.
• The interface can be added to a VLAN as an untagged member
regardless of connected devices to this interface. The default setting is
untagged VLAN 1. Note that each port can only have one untagged
To Next Page
Loading...
Need help?
General
