C
ONFIGURING
THE
S
WITCH
3-24
Figure 3-8. Bridge Extension Configuration
CLI – Enter the following command.
Managing Firmware
You can upload/download firmware to or from a TFTP server, or copy
files to and from switch units in a stack. By saving runtime code to a file on
a TFTP server, that file can later be downloaded to the switch to restore
operation. You can also set the switch to use new firmware without
overwriting the previous version. You must specify the method of file
transfer, along with the file type and file names as required.
Command Attributes
• File Transfer Method – The firmware copy operation includes these
options:
- file to file – Copies a file within the switch directory, assigning it a
new name.
- file to tftp – Copies a file from the switch to a TFTP server.
- tftp to file – Copies a file from a TFTP server to the switch.
• TFTP Server IP Address – The IP address of a TFTP server.
• File Type – Specify opcode (operational code) to copy firmware.
Console#config
Console(config)#jumbo frame
Console(config)#
To Next Page
Loading...
Need help?
General
