4-280
Command Mode
Global Configuration
Command Usage
Depending on your network connections, IGMP snooping may not
always be able to locate the IGMP querier. Therefore, if the IGMP
querier is a known multicast router/switch connected over the network
to an interface (port or trunk) on your router, you can manually
configure that interface to join all the current multicast groups.
Example
The following shows how to configure port 11 as a multicast router port
within VLAN 1:
show ip igmp snooping mrouter
This command displays information on statically configured and
dynamically learned multicast router ports.
Syntax
show ip igmp snooping mrouter [vlan vlan-id]
vlan-id - VLAN ID (Range: 1-4094)
Default Setting
Displays multicast router ports for all configured VLANs.
Command Mode
Privileged Exec
Command Usage
Multicast router port types displayed include Static.
Example
Console(config)#ip igmp snooping vlan 1 mrouter ethernet 1/11
Console(config)#
To Next Page
Loading...
Need help?
General
