S
WITCH
C
LUSTERING
3-259
Command Attributes
• Cluster Status – Enables or disables clustering on the switch.
• Cluster Commander – Enables or disables the switch as a cluster
Commander.
• Role – Indicates the current role of the switch in the cluster; either
Commander, Member, or Candidate.
• Cluster IP Pool – An “internal” IP address pool that is used to assign
IP addresses to Member switches in the cluster. Internal cluster IP
addresses are in the form 10.x.x.member-ID. Only the base IP address
of the pool needs to be set since Member IDs can only be between 1
and 36. Note that y
ou cannot change the cluster IP pool when the switch is currently
in Commander mode. Commander mode must first be disabled.
• Number of Members – The current number of Member switches in
the cluster.
• Number of Candidates – The current number of Candidate switches
discovered in the network that are available to become Members.
Web – Click Cluster, Configuration.
Figure 3-117. Cluster Configuration
To Next Page
Loading...
Need help?
General
