C
ONFIGURING
THE
S
WITCH
3-130
Figure 3-56. Port Broadcast Control
CLI – Specify any interface, and then enter the threshold. The following
disables broadcast storm control for port 1, and then sets broadcast
suppression at 500 kilobits per second for port 2.
Console(config)#interface ethernet 1/1 4-156
Console(config-if)#no switchport broadcast 4-164
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#switchport broadcast packet-rate 500 4-164
Console(config-if)#end
Console#show interfaces switchport ethernet 1/2 4-168
Information of Eth 1/2
Broadcast threshold: Enabled, 500 Kbits/second
LACP status: Disabled
Ingress Rate Limit: Disabled, 100000 Kbits per second
Egress Rate Limit: Disabled, 100000 Kbits per second
VLAN membership mode: Hybrid
Ingress rule: Enabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
GVRP status: Disabled
Allowed VLAN: 1(u),
Forbidden VLAN:
Private-VLAN mode: NONE
Private-VLAN host-association: NONE
Private-VLAN mapping: NONE
Console#
To Next Page
Loading...
Need help?
General
