A
UTHENTICATION
C
OMMANDS
4-111
dot1x system-auth-control
This command enables 802.1X port authentication globally on the switch.
Use the no form to restore the default.
Syntax
[no] dotx system-auth-control
Default Setting
Disabled
Command Mode
Global Configuration
Example
dot1x default
This command sets all configurable dot1x global and port settings to their
default values.
Command Mode
Global Configuration
Example
dot1x max-req
This command sets the maximum number of times the switch port will
retransmit an EAP request/identity packet to the client before it times out
the authentication session. Use the no form to restore the default.
Syntax
dot1x max-req count
no dot1x max-req
Console(config)#dot1x system-auth-control
Console(config)#
Console(config)#dot1x default
Console(config)#
To Next Page
Loading...
Need help?
General
