VLAN C
OMMANDS
4-239
Command Usage
• To assign a promiscuous port to a primary VLAN, use the switchport
private-vlan mapping command. To assign a host port to a
community VLAN, use the private-vlan host association command.
• To assign a promiscuous port or host port to an isolated VLAN, use
the switchport private-vlan isolated command.
Example
switchport private-vlan host-association
Use this command to associate an interface with a secondary VLAN. Use
the no form to remove this association.
Syntax
switchport private-vlan host-association secondary-vlan-id
no switchport private-vlan host-association
secondary-vlan-id - ID of secondary (i.e., community) VLAN.
(Range:
1-4094, no leading zeroes).
Default Setting
None
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
All ports assigned to a secondary (i.e., community) VLAN can pass
traffic between group members, but must communicate with resources
outside of the group via promiscuous ports in the associated primary
VLAN.
Console(config)#interface ethernet 1/2
Console(config-if)#switchport mode private-vlan promiscuous
Console(config-if)#exit
Console(config)#interface ethernet 1/3
Console(config-if)#switchport mode private-vlan host
Console(config-if)#
To Next Page
Loading...
Need help?
General
