VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
97
fqv3z"swkgv/rgtkqf"
Fguetkrvkqp"
The fqv3z"swkgv/rgtkqf command is used to enable the quiet-period function.
To disable the function, please use"pq"fqv3z"swkgv/rgtkqf command.
U{pvcz"
fqv3z"swkgv/rgtkqf"
pq"fqv3z"swkgv/rgtkqf"
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Enable the quiet-period function:
VN/UN764:G*eqphki+%fqv3z"swkgv/rgtkqf"
fqv3z"vkogqwv"
Fguetkrvkqp"
The fqv3z" vkogqwv" command is used to configure the quiet period and the
supplicant timeout. To restore to the default, please use"pq fqv3z" vkogqwv"
command.
U{pvcz"
fqv3z"vkogqwv {swkgv/rgtkqf"time | tgcwvj/rgtkqf"time}"
pq"fqv3z"vkogqwv"{quiet-period | reauth-period}"
Rctcogvgt"
swkgv/rgtkqf time ——The value for Quiet Period, ranging from 1 to 999 in
seconds. By default, it is 10. Once the supplicant failed to the 802.1X
Authentication, then the switch will not respond to the authentication request
from the same supplicant during the Quiet Period.
tgcwvj/rgtkqf time ——The maximum time for the switch to wait for the
response from supplicant before resending a request to the supplicant., ranging
from 1 to 9 in second. By default, it is 3.
To Next Page
Loading...
