TP-Link TL-SL5428E - show spanning-tree active; show spanning-tree bridge

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
211
U{pvcz"
urcppkpi/vtgg"oejgem"
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Enable MCheck for Fast Ethernet port 2:"
VN/UN764:G*eqphki+%kpvgthceg"hcuvGvjgtpgv"1/0/2"
VN/UN764:G*eqphki/kh+%urcppkpi/vtgg"oejgem"
ujqy"urcppkpi/vtgg"cevkxg"
Fguetkrvkqp"
The ujqy" urcppkpi/vtgg" cevkxg command is used to display the active
information of spanning-tree.
U{pvcz"
ujqy"urcppkpi/vtgg"cevkxg"
Eqoocpf"Oqfg"
Privileged EXEC Mode and Any Configuration Mode
Gzcorng"
Display the active information of spanning-tree:"
VN/UN764:G*eqphki+%ujqy"urcppkpi/vtgg"cevkxg"
ujqy"urcppkpi/vtgg"dtkfig"
Fguetkrvkqp"
The ujqy" urcppkpi/vtgg" dtkfig command is used to display the bridge
parameters.
U{pvcz"
ujqy"urcppkpi/vtgg"dtkfig"[ forward-time | hello-time | hold-count | max-age |
max-hops | mode | priority | state ]"
Eqoocpf"Oqfg"
Privileged EXEC Mode and Any Configuration Mode