TP-Link TL-SL5428E - ip igmp snooping filter maxgroup; ip igmp snooping filter mode

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
238
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Enable IGMP Snooping filter function for Gigabit Ethernet port 26:
VN/UN764:G*eqphki+%kpvgthceg ikicdkvGvjgtpgv"1/0/26"
VN/UN764:G*eqphki/kh+%kr"kior"upqqrkpi"hknvgt"
kr"kior"upqqrkpi"hknvgt"oczitqwr"
Fguetkrvkqp"
The" kr" kior" upqqrkpi" hknvgt" oczitqwr command is used to specify the
maximum number of multicast groups for a port to join in.
U{pvcz"
kr"kior"upqqrkpi"hknvgt"oczitqwr maxgroup
Rctcogvgt"
maxgroup —— The maximum number of multicast groups for a port to join in. It
is used to prevent some ports taking up too much bandwidth.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Specify the maximum number of multicast groups for Fast Ethernet ports 2-5 to
join in as 10:
VN/UN764:G*eqphki+%kpvgthceg tcpig"hcuvGvjgtpgv"1/0/2-5"
VN/UN764:G*eqphki/kh/tcpig+#kr"kior"upqqrkpi"hknvgt"oczitqwr"10"
kr"kior"upqqrkpi"hknvgt"oqfg"
Fguetkrvkqp"
The kr"kior"upqqrkpi"hknvgt"oqfg command is used to configure the Action
mode for the desired port.
U{pvcz"
kr"kior"upqqrkpi"hknvgt"oqfg mode