TP-Link TL-SL5428E - ethernet-oam remote-failure

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
220
Gzcorng"
For error frame seconds event, configure the error threshold as 8 and the event
detection interval as 30 seconds on Fast Ethernet port 5:
VN/UN764:G*eqphki+%"kpvgthceg"hcuvGvjgtpgv"1/0/5"
VN/UN764:G*eqphki/kh+%" gvjgtpgv/qco" nkpm/oqpkvqt" htcog/ugeqpfu"
vjtgujqnf"8"ykpfqy"300"
gvjgtpgv/qco"tgoqvg/hcknwtg"
Fguetkrvkqp"
The ethernet-oam remote-failure command is used to configure whether to
notify the link faults or not. The link faults include dying gasp and critical event.
To return to the default configurations, please use pq" gvjgtpgv/qco"
tgoqvg/hcknwtg"command.
U{pvcz"
gvjgtpgv/qco" tgoqvg/hcknwtg" {" dying-gasp | critical-event" }" pqvkh{" {" disable |
enable }
pq"gvjgtpgv/qco"tgoqvg/hcknwtg"{"dying-gasp | critical-event"}"pqvkh{"
Rctcogvgt"
dying-gasp —— Dying Gasp link event. Dying gasp means an unrecoverable
fault, such as power failure, occurs.
critical-event —— Critical Event. Critical-event means unspecified critical event
occurs.
notify ——Enable/Disable the event notification. By default, it is enabled.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Disable the Dying Gasp link event notification on Fast Ethernet port 7:
VN/UN764:G*eqphki+%"kpvgthceg"hcuvGvjgtpgv 1/0/7