VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
32
oce/xncp"
Fguetkrvkqp"
The oce/xncp" command is used to enable a port for the MAC-based VLAN
feature. Only the port is enabled can the configured MAC-based VLAN take
effect. To disable the MAC-based VLAN function, please use pq" oce/xncp"
command. All the ports are disabled by default.
U{pvcz"
oce/xncp"
pq"oce/xncp
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Enable the Fast Ethernet port 3 for the MAC-based VLAN feature:
VN/UN764:G*eqphki+%kpvgthceg"hcuvGvjgtpgv"1/0/3
VN/UN764:G*eqphki/kh+%oce/xncp"
ujqy"oce/xncp
Fguetkrvkqp"
The ujqy" oce/xncp command is used to display the information of the
MAC-based VLAN entry. MAC address and VLAN ID can be used to filter the
displayed information.
U{pvcz"
ujqy"oce/xncp {"cnn"|"oce/cfftguu"mac-addr | xncp"vlan-id }"
Eqoocpf"Oqfg"
Privileged EXEC Mode and Any Configuration Mode
Rctcogvgt"
mac-addr —— MAC address, in the format of XX:XX:XX:XX:XX:XX.
vlan-id —— Specify IEEE 802.1Q VLAN ID, ranging from 1 to 4094.
To Next Page
Loading...
