TP-Link TL-SL5428E - switchport general allowed vlan; switchport pvid

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
28
uykvejrqtv"igpgtcn"cnnqygf"xncp
Fguetkrvkqp"
The uykvejrqtv" igpgtcn" cnnqygf" xncp command is used to add the desired
General port to IEEE 802.1Q VLAN, or to remove a port from the corresponding
VLAN.
U{pvcz"
uykvejrqtv"igpgtcn"cnnqygf"xncp"vlan-list { tagged | untagged }"
pq"uykvejrqtv"igpgtcn"cnnqygf"xncp"vlan-list
Rctcogvgt"
vlan-list —— VLAN ID list, ranging from 2 to 4094, in the format of 2-3, 5. It is
multi-optional.
tagged | untagged —— egress-rule.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Configure Fast Ethernet port 4 whose link type is “general” to VLAN 2 and its
egress-rule as “tagged”:
VN/UN764:G*eqphki+%kpvgthceg"hcuvGvjgtpgv 1/0/4
VN/UN764:G*eqphki/kh+%uykvejrqtv"oqfg"general
VN/UN764:G*eqphki/kh+%uykvejrqtv"igpgtcn"cnnqygf xncp"2 tagged
uykvejrqtv"rxkf
Fguetkrvkqp"
The uykvejrqtv" rxkf command is used to configure the PVID for the switch
ports.
U{pvcz"
uykvejrqtv"rxkf"vlan-id