TP-Link TL-SL5428E - switchport mode; switchport access vlan

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
26
Gzcorng"
Specify the description string of the VLAN 2 as “VLAN002”:
VN/UN764:G*eqphki+%xncp"2"
VN/UN764:G*eqphki/xncp+%pcog"VLAN002"
uykvejrqtv"oqfg
Fguetkrvkqp"
The uykvejrqtv" oqfg command is used to configure the Link Types for the
ports.
U{pvcz"
uykvejrqtv"oqfg { access | trunk | general }
Rctcogvgt"
access | trunk | general —— Link Types. There are three Link Types for the
ports.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Specify the Link Type of Fast Ethernet port 3 as “trunk”:
VN/UN764:G*eqphki+%kpvgthceg"hcuvGvjgtpgv"1/0/3
VN/UN764:G*eqphki/kh+%uykvejrqtv"oqfg trunk"
uykvejrqtv"ceeguu"xncp
Fguetkrvkqp"
The uykvejrqtv"ceeguu"xncp command is used to add the desired Access port
to IEEE 802.1Q VLAN, or to remove a port from the corresponding VLAN.
U{pvcz"
uykvejrqtv"ceeguu"xncp"vlan-id"
pq"uykvejrqtv"ceeguu"xncp"