VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
109
Koogfkcvg—— The system log file in the buffer will be synchronized to the flash
immediately. This option will reduce the life of the flash and is not
recommended.
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Specify the log file synchronization frequency as 10 hours:
VN/UN764:G*eqphki+%"nqiikpi"hkng"hncuj"htgswgpe{"rgtkqfke10"
nqiikpi"hkng"hncuj"ngxgn"
Fguetkrvkqp"
The nqiikpi" hkng" hncuj" ngxgn command is used to specify the system log
message severity level. Messages will a severity level equal to or higher than
this value will be stored to the flash. To restore to the default level, please use
pq"nqiikpi"hkng"hncuj"ngxgn"command."
U{pvcz"
nqiikpi"hkng"hncuj"ngxgn"level
pq"nqiikpi"hkng"hncuj"ngxgn"
Rctcogvgt"
level —— Severity level of the log information. There are 8 severity levels
marked with values 0-7. The smaller value has the higher priority. Only the log
with the same or smaller severity level value will be output. By default, it is 2
indicating that the log information marked with 0–2 will be saved in the log
buffer.
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Enable the log file function and set the severity as 7:
VN/UN764:G*eqphki+%nqiikpi"hkng"hncuj"ngxgn"7"
To Next Page
Loading...
