VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
130
backup-ntp-server —— The IP address for the Secondary NTP Server.
fetching-rate —— Specify the rate fetching time from NTP server.
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Configure the system time mode as NTP, the time zone is UTC-12:00, the
primary NTP server is 133.100.9.2 and the secondary NTP server is
139.78.100.163, the fetching-rate is 11 hours:
VN/UN764:G*eqphki+%u{uvgo/vkog"pvr"UTC-12:00 133.100.9.2 139.79.100.163
11"
u{uvgo/vkog"fuv"rtgfghkpgf"
Fguetkrvkqp"
The"u{uvgo/vkog"fuv"rtgfghkpgf"command is used to select a predefined DST
configuration and the configuration can be recycled.
U{pvcz"
u{uvgo/vkog"fuv"rtgfghkpgf [ USA | Australia | European | New-Zealand ]
Rctcogvgt"
USA | Australia | European | New-Zealand —— Predefined DST mode, with
four options: USA, Australia, European and New-Zealand. By default, the
setting is “European”.
The DST time periods which the four predefined DST mode represents are
displayed as follow:
USA: Second Sunday in March, 02:00 – First Sunday in November, 02:00.
Australia: First Sunday in October, 02:00 – First Sunday in April, 03:00.
European: Last Sunday in March, 01:00 – Last Sunday in October, 01:00.
New Zealand: Last Sunday in September, 02:00 – First Sunday in April, 03:00.
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Configure the DST period of the switch as European:
VN/UN764:G*eqphki+%u{uvgo/vkog"fuv"rtgfghkpgf"European"
To Next Page
Loading...
