TP-Link TL-SL5428E - ipv6 mld snooping vlan immediate-leave; ipv6 mld snooping vlan mrouter

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
254
Gzcorng"
Specify the member port aging time as 100 seconds in VLAN 2:
VN/UN764:G*eqphki+%"krx8"onf"upqqrkpi"xncp 2"ogodgt/cikpi/vkog 100"
krx8"onf"upqqrkpi"xncp"koogfkcvg/ngcxg"
Fguetkrvkqp"
The"krx8"onf"upqqrkpi"xncp"koogfkcvg/ngcxg command is used to enable the
immediate leave function on a specified VLAN. To disable this funciton, please
use pq"krx8"onf"upqqrkpi"xncp"koogfkcvg/ngcxg command. By default, it is
disabled.
U{pvcz"
krx8"onf"upqqrkpi"xncp"vlan-id"koogfkcvg/ngcxg"
pq"krx8"onf"upqqrkpi"xncp"vlan-id"koogfkcvg/ngcxg"
Rctcogvgt"
vlan-id —— The specified IEEE 802.1Q VLAN ID to enable the immediate leave
function, ranging from 1 to 4094.
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Enable immediate leave function on VLAN 2:
VN/UN764:G*eqphki+%"krx8"onf"upqqrkpi"xncp"2 koogfkcvg/ngcxg"
krx8"onf"upqqrkpi"xncp"otqwvgt"
Fguetkrvkqp"
The"krx8"onf"upqqrkpi" xncp"otqwvgt command is used to configure the static
router port in a specified VLAN. To disable the static router port, please use pq"
onf"upqqrkpi"xncp"otqwvgt command.
U{pvcz"
krx8"onf"upqqrkpi"xncp"vlan-id"otqwvgt"kpvgthceg"ikicdkvGvjgtpgv"port"
pq"krx8"onf"upqqrkpi"xncp"vlan-id"otqwvgt"]kpvgthceg"ikicdkvGvjgtpgv"port_"
Rctcogvgt"
vlan-id ——The specified IEEE 802.1Q VLAN ID, ranging from 1 to 4094.
port —— Interface number of the router port(s).