VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
209
VN/UN764:G*eqphki+%kpvgthceg"hcuvGvjgtpgv"1/0/2"
VN/UN764:G*eqphki/kh+%urcppkpi/vtgg"drfwiwctf"
urcppkpi/vtgg"iwctf"nqqr"
Fguetkrvkqp"
The urcppkpi/vtgg"iwctf"nqqr"command is used to enable the Loop Protect
function for a port. Loop Protect is to prevent the loops in the network brought by
recalculating STP because of link failures and network congestions. To disable
the Loop Protect function, please use pq"urcppkpi/vtgg"iwctf"nqqr command.
U{pvcz"
urcppkpi/vtgg"iwctf"nqqr
pq"urcppkpi/vtgg"iwctf"nqqr"
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Enable the Loop Protect function for Fast Ethernet port 2:
VN/UN764:G*eqphki+%kpvgthceg"hcuvGvjgtpgv"1/0/2"
VN/UN764:G*eqphki/kh+%urcppkpi/vtgg"iwctf"nqqr"
urcppkpi/vtgg"iwctf"tqqv"
Fguetkrvkqp"
The urcppkpi/vtgg" iwctf" tqqv"command is used to enable the Root Protect
function for a port. With the Root Protect function enabled, the root bridge will
set itself automatically as ERROR-PORT when receiving BPDU packets with
higher priority, in order to maintain the role of root bridge. To disable the Root
Protect function, please use pq"urcppkpi/vtgg"iwctf"tqqv command.
U{pvcz"
urcppkpi/vtgg"iwctf"tqqv
pq"urcppkpi/vtgg"iwctf"tqqv"
To Next Page
Loading...
