TP-Link TL-SL5428E - storm-control multicast

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
157
Rctcogvgt"
rate —— Specify the bandwidth for receiving broadcast packets on the port.
The packet traffic exceeding the bandwidth will be discarded. By default, the
value is “128K”."
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Enable the broadcast control function for Fast Ethernet port 5:
VN/UN764:G*eqphki+%kpvgthceg"hcuvGvjgtpgv"1/0/5
VN/UN764:G*eqphki/kh+%uvqto/eqpvtqn"dtqcfecuv"
uvqto/eqpvtqn"ownvkecuv"
Fguetkrvkqp"
The"uvqto/eqpvtqn"ownvkecuv"command is used to enable the multicast control
function. To disable the multicast control function, please use pq"uvqto/eqpvtqn"
ownvkecuv" command. Multicast control function allows the switch to filter
multicast in the network. If the transmission rate of the multicast packets
exceeds the set bandwidth, the packets will be automatically discarded to avoid
network broadcast storm.
U{pvcz"
uvqto/eqpvtqn ownvkecuv"[tcvg rate]
pq"uvqto/eqpvtqn"ownvkecuv" "
Rctcogvgt"
rate —— Select the bandwidth for receiving multicast packets on the port. The
packet traffic exceeding the bandwidth will be discarded. By default, the value is
“128K”.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Enable the multicast control function for Fast Ethernet port 5:
VN/UN764:G*eqphki+%kpvgthceg"hcuvGvjgtpgv"1/0/5