VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
140
Upgrade the switch system file named as firmware.bin via the TFTP server with
the IP address fe80::1234
VN/UN764:G%"hktoyctg"writcfg"kr/cfftguu"fe80::1234"hkngpcog"firmware.bin
rkpi"
Fguetkrvkqp"
The rkpi"command is used to test the connectivity between the switch and one
node of the network.
U{pvcz"
rkpi"[ ip | ipv6 ] { ip_addr } [ /p count ] [ /n count ] [ /k count ]
Rctcogvgt"
ip —— The type of the IP address for ping test should be IPv4.
ipv6 —— The type of the IP address for ping test should be IPv6.
ip_addr —— The IP address of the destination node for ping test. If the
parameter ip/ipv6 is not selected, both IPv4 and IPv6 addresses are supported,
for example 192.168.0.100 or fe80::1234.
/p count —— The amount of times to send test data during Ping testing. It
ranges from 1 to 10. By default, this value is 4.
/n count —— The size of the sending data during ping testing. It ranges from 1
to 1024 bytes. By default, this value is 64.
/k count —— The interval to send ICMP request packets. It ranges from 100 to
1000 milliseconds. By default, this value is 1000.
Eqoocpf"Oqfg"
User EXEC Mode and Privileged EXEC Mode
Gzcorng"
To test the connectivity between the switch and the network device with the IP
192.168.0.131, please specify the count (-l) as 512 bytes and count (-i) as 1000
milliseconds. If there is not any response after 8 times’ Ping test, the connection
between the switch and the network device is failed to establish:
VN/UN764:G%"rkpi"192.168.0.131 ⁄p"8"⁄n"512"
To test the connectivity between the switch and the network device with the IP
fe80::1234, please specify the count (-l) as 512 bytes and count (-i) as 1000
To Next Page
Loading...
