TP-Link TL-SL5428E - ethernet-oam link-monitor frame-seconds

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
219
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
For error frame period event, configure the error threshold as 6 and the event
detection interval as 150000 frames on Fast Ethernet port 4:
VN/UN764:G*eqphki+%"kpvgthceg"hcuvGvjgtpgv"1/0/4"
VN/UN764:G*eqphki/kh+%" gvjgtpgv/qco" nkpm/oqpkvqt"htcog/rgtkqf"vjtgujqnf"
6"ykpfqy"150000"
gvjgtpgv/qco"nkpm/oqpkvqt"htcog/ugeqpfu
Fguetkrvkqp"
The gvjgtpgv/qco nkpm/oqpkvqt"htcog/ugeqpfu command is used to configure
the parameters about one of the link events, error frame seconds event. To
return to the default configurations, please use pq"gvjgtpgv/qco"nkpm/oqpkvqt"
htcog/ugeqpfu command.
U{pvcz"
gvjgtpgv/qco"nkpm/oqpkvqt"htcog/ugeqpfu"{ [vjtgujqnf"threshold"] [ ykpfqy"
window"] [pqvkh{ {"disable | enable } ] }
pq"gvjgtpgv/qco"nkpm/oqpkvqt"htcog/ugeqpfu"{ threshold | window | notify"}
Rctcogvgt"
threshold —— Configure the error threshold for generating error frame seconds
event. The range is from 1 to 900 and the default value is 1.
window —— Configure the error frame seconds event detection interval. The
range is from 100 to 9000, in terms of 100 ms intervals. The default value is 600.
notify —— Enable/Disable the event notification. By default, it is enabled.
threshold | window | notify —— The parameter that you want to return to the
default configuration.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)