VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
273
Gzcorng"
Specify the local engineID as 1234567890, and the remote engineID as
abcdef123456:
VN/UN764:G*eqphki+%upor/ugtxgt" gpikpgKF" nqecn" 1234567890" tgoqvg"
abcdef123456"
upor/ugtxgt"vtcru"upor"
Fguetkrvkqp"
The upor/ugtxgt vtcru" upor command is used to enable SNMP standard
traps which include five types: linkup, linkdown, warmstart, coldstart, and
auth-failure. To disable the sending of SNMP standard traps, please use pq"
upor/ugtxgt"vtcru"upor command.
Pqvg<" "
The upor/ugtxgt" vtcru" upor" command without any parameter is used to
enable all the five types of traps. And the pq upor/ugtxgt" vtcru" upor"
command without any parameter is used to disable all the five types of traps.
U{pvcz"
upor/ugtxgt" vtcru" upor [ linkup | linkdown | warmstart | coldstart |
auth-failure ]
pq" upor/ugtxgt" vtcru" upor" [ linkup | linkdown | warmstart | coldstart |
auth-failure ]"
Rctcogvgt"
linkup —— Enable the linkup trap. It is sent when port status changes from
linkdown to linkup. By default, it is enabled.
linkdown ——Enable the linkdown trap. It is sent when port status changes from
linkup to linkdown. By default, it is enabled.
warmstart —— Enable the warmstart trap. It is sent upon SNMP function reboot.
By default, it is enabled.
coldstart —— Enable the coldstart trap. It is sent upon switch reboot. By default,
it is enabled.
auth-failure —— Enable the auth-failure trap. It is sent when a received SNMP
request fails the authentication. By default, it is enabled.
Eqoocpf"Oqfg"
Global Configuration Mode
To Next Page
Loading...
