TP-Link TL-SL5428E - switchport dot1 q-tunnel mapping; switchport dot1 q-tunnel mode uplink

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
40
uykvejrqtv"fqv3s/vwppgn"ocrrkpi
Fguetkrvkqp"
The uykvejrqtv"fqv3s/vwppgn"ocrrkpi command is used to enable the VLAN
Mapping feature for a specified port. To disable the VLAN Mapping feature of
this port, please use the pq"uykvejrqtv"fqv3s/vwppgn"ocrrkpi command. By
default, the VLAN Mapping feature of all ports is disabled."
U{pvcz"
uykvejrqtv"fqv3s/vwppgn"ocrrkpi
pq"uykvejrqtv"fqv3s/vwppgn"ocrrkpi
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Enable the VLAN Mapping feature for the Fast Ethernet port 3:
VN/UN764:G*eqphki+%kpvgthceg"hcuvGvjgtpgv"1/0/3
VN/UN764:G*eqphki/kh+%uykvejrqtv"fqv3s/vwppgn"ocrrkpi"
uykvejrqtv"fqv3s/vwppgn"oqfg"wrnkpm
Fguetkrvkqp"
The" uykvejrqtv" fqv3s/vwppgn" oqfg" wrnkpm command is used to configure a
specified port as the VPN Up-link port. To cancel this VPN Up-link port, please
use the" pq" uykvejrqtv" fqv3s/vwppgn" oqfg" wrnkpm" command. By default, no
port has been configured as the VPN Up-link port.
U{pvcz"
uykvejrqtv"fqv3s/vwppgn"oqfg"wrnkpm
pq"uykvejrqtv"fqv3s/vwppgn"oqfg"wrnkpm
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)