TP-Link TL-SL5428E - Chapter 1 Using the CLI; 1.1 Accessing the CLI; 1.1.1 Logon by a console port

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
5
Ejcrvgt"3" Wukpi"vjg"ENK"
303" " Ceeguukpi"vjg"ENK"
You can log on to the switch and access the CLI by the following three methods:
1. Log on to the switch by the console port on the switch.
2. Log on to the switch remotely by a Telnet connection through an Ethernet port.
3. Log on to the switch remotely by an SSH connection through an Ethernet port.
30303" Nqiqp"d{"c"eqpuqng"rqtv"
Take the following steps to log on to the switch by the console port.
1. Connect the PCs or Terminals to the console port on the switch by the provided cable.
2. Start the terminal emulation program (such as the HyperTerminal) on the PC.
3. Configure the terminal emulation program or the terminal to use the following settings:
 Baud rate: 38400 bps
 Data bits: 8
 Parity: none
 Stop bits: 1
 Flow control: none
4. The DOS prompt “TL-SL5428E>” will appear after pressing the Enter button as shown in
Figure 1-1. It indicates that you can use the CLI now.