VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
108
nqiikpi"hkng"hncuj"
Fguetkrvkqp"
The nqiikpi"hkng"hncuj command is used to configure the level and the status of
the log file input. To disable the logging file flash funtion, please use pq nqiikpi"
hkng"hncuj"command. The log file indicates the flash sector for saving system log.
The information in the log file will not be lost after the switch is restarted and can
be got by the ujqy"nqiikpi"hncuj
"command."
U{pvcz"
nqiikpi"hkng"hncuj
pq"nqiikpi"hkng"hncuj"
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Enable the log file function and set the severity as 7:
VN/UN764:G*eqphki+%nqiikpi"hkng"hncuj"7"
nqiikpi"hkng"hncuj"htgswgpe{"
Fguetkrvkqp"
The nqiikpi"hkng"hncuj"htgswgpe{"command is used to specify the frequency to
synchronize the system log file in the log buffer to the flash. To resume the
default synchronizing frequency, please use the pq" nqiikpi" hkng" hncuj"
htgswgpe{"command."
U{pvcz"
nqiikpi"hkng"hncuj"htgswgpe{"{ rgtkqfke"periodic ~"koogfkcvg"}
pq"nqiikpi"hkng"hncuj"htgswgpe{"
Rctcogvgt"
periodic ——The frequency to synchronize the system log file in the log buffer to
the flash, ranging from 1 to 48 hours. By default, the synchronization process
takes place every 24 hours.
To Next Page
Loading...
