TP-Link TL-SL5428E - shutdown; flow-control

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
154
ujwvfqyp
Fguetkrvkqp"
The" ujwvfqyp" command is used to disable an Ethernet port. To enable this
port again, please use pq"ujwvfqyp"command.
U{pvcz"
ujwvfqyp"
pq"ujwvfqyp"
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Disable Gigabit Ethernet port 25:
VN/UN764:G*eqphki+%kpvgthceg"ikicdkvGvjgtpgv"1/0/25
VN/UN764:G*eqphki/kh+%ujwvfqyp"
hnqy/eqpvtqn"
Fguetkrvkqp"
The"hnqy/eqpvtqn"command is used to enable the flow-control function for a port.
To disable the flow-control function for this corresponding port, please use pq"
hnqy/eqpvtqn" command. With the flow-control function enabled, the Ingress
Rate and Egress Rate can be synchronized to avoid packet loss in the network.
U{pvcz"
hnqy/eqpvtqn"
pq"hnqy/eqpvtqn"
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Enable the flow-control function for Gigabit Ethernet port 25:
VN/UN764:G*eqphki+%kpvgthceg"ikicdkvGvjgtpgv"1/0/25
VN/UN764:G*eqphki/kh+%hnqy/eqpvtqn"