VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
215
Ejcrvgt"53" Gvjgtpgv"QCO"Eqoocpfu"
Ethernet OAM (standing for Operation, Administration, and Maintenance) is Layer 2 protocol that
is used for monitoring and troubleshooting Ethernet networks. It can report the network status to
network administrators through the OAMPDUs exchanged between two OAM entities. The
operation of OAM on an Ethernet interface does not adversely affect data traffic as OAM is a slow
protocol with very limited bandwidth potential.
gvjgtpgv/qco
Fguetkrvkqp"
The gvjgtpgv/qco command is used to enable the Ethernet OAM function for
the desired port. To disable the Ethernet OAM function, please use pq"
gvjgtpgv/qco command.
U{pvcz"
gvjgtpgv/qco
pq"gvjgtpgv/qco
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Enable the Ethernet OAM function for Fast Ethernet port 2:
VN/UN764:G*eqphki+%"kpvgthceg"hcuvGvjgtpgv"1/0/2"
VN/UN764:G*eqphki/kh+%gvjgtpgv/qco"
gvjgtpgv/qco"oqfg
Fguetkrvkqp"
The gvjgtpgv/qco oqfg"command is used to configure the OAM mode for the
desired port. To return to the default configurations, please use pq"
gvjgtpgv/qco"oqfg command. The default mode is active.
To Next Page
Loading...
