VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
287
Ejcrvgt"58" NNFR"Eqoocpfu"
LLDP function enables network devices to advertise their own device information periodically to
neighbors on the same LAN. The information of the LLDP devices in the LAN can be stored by its
neighbor in a standard MIB, so it is possible for the information to be accessed by a Network
Management System (NMS) using SNMP.
nnfr" "
Fguetkrvkqp"
The nnfr" command is used to enable LLDP function. To disable the LLDP
function, please use pq"nnfr command.
U{pvcz"
nnfr" "
pq"nnfr" "
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Enable LLDP function globally:
VN/UN764:G*eqphki+%nnfr" "
nnfr"jqnf/ownvkrnkgt"
Fguetkrvkqp"
The nnfr" jqnf/ownvkrnkgt command is used to configure the Hold Multiplier
parameter. The aging time of the local information in the neighbor device is
determined by the actual TTL value used in the sending LLDPDU. TTL = Hold
Multiplier * Transmit Interval. To return to the default configuration, please use
pq"nnfr"jqnf/ownvkrnkgt command.
U{pvcz"
nnfr"jqnf/ownvkrnkgt"multiplier
pq"nnfr"jqnf/ownvkrnkgt"
To Next Page
Loading...
