VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
217
notify —— Enable/Disable the event notification. By default, it is enabled.
threshold | window | notify —— The parameter that you want to return to the
default configuration.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
For error symbol-period event, configure the error threshold as 5 and the event
detection interval as 3 seconds on Fast Ethernet port 2:
VN/UN764:G*eqphki+%"kpvgthceg"hcuvGvjgtpgv 1/0/2"
VN/UN764:G*eqphki/kh+%" gvjgtpgv/qco" nkpm/oqpkvqt" u{odqn/rgtkqf"
vjtgujqnf"5"ykpfqy 30"
gvjgtpgv/qco"nkpm/oqpkvqt"htcog
Fguetkrvkqp"
The gvjgtpgv/qco nkpm/oqpkvqt" htcog command is used to configure the
parameters about one of the link events, error frame event. To return to the
default configurations, please use pq" gvjgtpgv/qco" nkpm/oqpkvqt" htcog
command.
U{pvcz"
gvjgtpgv/qco"nkpm/oqpkvqt"htcog"{ [vjtgujqnf"threshold"] [ ykpfqy"window"]
[pqvkh{ {"disable | enable } ] }
pq"gvjgtpgv/qco"nkpm/oqpkvqt"htcog"{ threshold | window | notify"}
Rctcogvgt"
threshold —— Configure the error threshold for generating error frame event.
The range is from 1 to 4294967295 and the default value is 1.
window —— Configure the error symbol-period event detection interval. The
range is from 10 to 600, in terms of 100 ms intervals. The default value is 10.
notify —— Enable/Disable the event notification. By default, it is enabled.
threshold | window | notify —— The parameter that you want to return to the
default configuration.
To Next Page
Loading...
