VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
58
Ejcrvgt"32" Gvjgtejcppgn"Eqoocpfu"
Etherchannel Commands are used to configure LAG and LACP function.
LAG (Link Aggregation Group) is to combine a number of ports together to make a single
high-bandwidth data path, which can highly extend the bandwidth. The bandwidth of the LAG is
the sum of bandwidth of its member port.
LACP (Link Aggregation Control Protocol) is defined in IEEE802.3ad and enables the dynamic link
aggregation and disaggregation by exchanging LACP packets with its partner. The switch can
dynamically group similarly configured ports into a single logical link, which will highly extend the
bandwidth and flexibly balance the load.
ejcppgn/itqwr"
Fguetkrvkqp"
The"ejcppgn/itqwr"command is used to add a port to the EtherChannel Group
and configure its mode. To delete the port from the EtherChannel Group, please
use"pq"ejcppgn/itqwr command.
U{pvcz"
ejcppgn/itqwr num oqfg"{ on | active | passive }
pq ejcppgn/itqwr
Rctcogvgt"
num —— The number of the EtherChannel Group, ranging from 1 to 14.
on —— Enable the static LAG.
active —— Enable the active LACP mode.
passive —— Enable the passive LACP mode.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEhternet)
Gzcorng"
Add the Fast Ethernet port 2-4 to EtherChannel Group 1 and enable the static
LAG:
VN/UN764:G*eqphki+%kpvgthceg"tcpig"hcuvGvjgtpgv"1/0/2-4
VN/UN764:G*eqphki/kh/tcpig+%ejcppgn/itqwr 1"oqfg on"
To Next Page
Loading...
