TP-Link TL-SL5428E - ipv6 mld snooping querier vlan query-interval; ipv6 mld snooping querier vlan query-source

VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
257
krx8"onf"upqqrkpi"swgtkgt"xncp"swgt{/kpvgtxcn"
Fguetkrvkqp"
The" k rx8" onf" upqqrkpi" swgtkgt" xncp" swgt{/kpvgtxcn command is used to
specify the interval to send the Query Message. The default value is 25 seconds.
To restore the default value, please use pq"krx8"onf"upqqrkpi"swgtkgt" xncp"
swgt{/kpvgtxcn command.
U{pvcz"
krx8"onf"upqqrkpi"swgtkgt"xncp"vlan-id swgt{/kpvgtxcn"interval"
pq"krx8"onf"upqqrkpi"swgtkgt"xncp"vlan-id swgt{/kpvgtxcn"
Rctcogvgt"
vlan-id ——The VLAN that enables the MLD Querier function, ranging from 1 to
4094.
interval —— Specify the interval to send the Query message in seconds,
ranging from 2 to 300.
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Specify the interval to send the Query Message as 10s on VLAN 2:
VN/UN764:G*eqphki+%"krx8"onf"upqqrkpi"swgtkgt"xncp"2 swgt{/kpvgtxcn"10"
krx8"onf"upqqrkpi"swgtkgt"xncp"swgt{/uqwteg"
Fguetkrvkqp"
The" krx8" onf" upqqrkpi" swgtkgt" xncp" swgt{/uqwteg command is used to
specify the source address which sends the Query message. The default value
is FE80::02FF:FFFF:FE00:0001. To restore the default value, please use pq"
krx8"onf"upqqrkpi"swgtkgt"xncp"swgt{/uqwteg command.
U{pvcz"
krx8"onf"upqqrkpi"swgtkgt"xncp"vlan-id swgt{/uqwteg"ipv6-addr"
pq"krx8"onf"upqqrkpi"swgtkgt"xncp"vlan-id swgt{/uqwteg"
Rctcogvgt"
vlan-id —— IEEE 802.1Q VLAN ID, ranging from 1 to 4094.
ipv6-addr —— Specify the IPv6 source address.
Eqoocpf"Oqfg"
Global Configuration Mode